Routing The Fog Light Harness Continued..
14. Route the fog light harness 2-pin connector (long finish) up along the bulkhead aspect stay, then alongside the vehicle harness behind the front bulkhead upper frame.
15. Continue routing the fog light harness 2-pin connector forward, then all the way down to the underside of the front facet frame along the outside of the suitable bulkhead side stay.
16. Connect the three wire ties with clip on the fog mild harness into the holes in the bulkhead facet stay. Further secure the fog lights harness to the vehicle harness with two wire ties in the areas shown without engine block heater.
17. Secure the fog gentle harness to the outlet with the wire tie as shown.
18. Safe the fog light harness to the holes within the bulkhead facet stay and the left front bulkhead with the 4 wire ties with clip.
19. Secure the fog gentle harness to the vehicle harness with one wire tie.
20. Connect the two wire ties with clip on the fog gentle harness into the holes below the entrance facet frame and the bulkhead facet stay.
21. Safe the fog lights harness to the vehicle harness with six wire ties.
22. Whereas holding the front bumper close to the front of the automobile, plug the fog light harness 2-pin connectors into the 2-pin connectors from the fog lights. Reinstall the entrance bumper.
Routing the Switch Harness
23. Take away the driving force’s dashboard lower cover, turn the knobs clockwise, then pull the quilt out toward you to release the six retaining tabs.
24. Decrease the steering wheel using the tilt lever. Remove the 2 self-tapping screws and one washer-screw from the decrease steering column cover.
25. Separate the upper steering column cowl from the lower steering column cover. •Turn the steering wheel 90° clockwise and, press the purpose to launch the retaining tab. •Press level after which to release the retaining tabs. As soon as these retaining tabs are launched, the retaining tabs on the alternative facet will release.
26. Slide the relay bracket onto the change harness relay block.
27. Slide the relay onto the change harness relay block.
28. Below the dashboard, install the relay bracket on the info link connector bracket using a washer- bolt and flange nut.